Conversation
jmorris

James Morris

Finally completed the initial version of 'fp_util', which allows you to control & monitor an Eltek Flatpack2 power supply, using an Arduino with a CAN bus shield.

https://github.com/xjamesmorris/fp_util

These PSUs are intended for telecoms racks, as chargers for 48v batteries, and supply 2kW or 3kW. Surplus units are useful for LDMOS RF amplifiers, and EV / e-bike etc. battery charging.
0
0
1
About social.kernel.org

Terms of service

  1. Please do not use this service in violation of the Linux Kernel Code of Conduct. Doing so will result in your account suspension with the referral of the matter to the CoC committee.

  2. "Repeating"/"boosting" someone else's status on this platform will be treated as endorsement and will fall under rule #1.

  3. You are encouraged to use this platform to promote your work on the Linux Kernel, but there is no restriction on permitted topics (with the exception of anything covered by #1 above).

  4. There is no requirement to post in English, but it should be considered the primary language of communication on this platform.

Privacy notice

The admins of this service have access to all posted statuses. They aren't looking, but if it's something they shouldn't know about, then you should not post it on this platform.

Please see the Linux Foundation Privacy Policy, which applies to this platform as well.

Getting your own account

If you would like an account on this instance, please check that the following applies to you:

  • You are listed in MAINTAINERS or CREDITS

  • OR: You have a kernel.org account or email address

  • OR: You have a long and established history of involvement with the Linux Kernel

If the above is true and you agree with the Terms of Service and Privacy Notice listed above, please use these instructions to request an account: